Owner: Department of Public Safety & Correctional Services
This project was a collaborated effort to construct a new facility while maintaining and restoring the historic building façade.
On site work included:
Addition and renovation of kitchen and dining facility
Concrete and brick work
Structural steel, millwork and roofing
Interior finishes and door hardware
Mechanical, electrical, sprinkler and walk in boxes
The project required high level of security and hygiene while working. Project planning and execution was a challenge for reasons listed below:
Kitchen prepares about 7,500 meals per day, operational almost all the time
Phased project with extensive coordination to keep the old kitchen operational
Addition was completed while the kitchen and dining room was operational
Carter Barron Amphitheatre
Washington, DC
Owner: National Park Service
This project was a collaborated effort to construct a new facility while maintaining and restoring the historic building façade.
On site work included:
Site Electrical, and Utilities
Stone Work
New 4000 Seats
Emergency generator UPS Backup system
Installation of two electrical towers
2 New Electrical Systems
The project posed several challenges that were met while execution:
Work was completed during the cold winter months
Poor soil was discovered which was needed to be replaced
Despite additional work and poor weather the project was completed on time
Engine Company Replacement
Engine Company #20, Washington, DC
Owner: Government of the District of Columbia
This project was a collaborated effort to construct a new facility while maintaining and restoring the historic building façade.
On site work included:
Face brick and stone masonry
Concrete and brick work
Wood windows and landscape work
Emergency generator UPS Backup system
Installation of three sliding poles with automatic shutters
Installation of commercial kitchen and dining facility
Complete Mechanical, Electrical, Dry|Wet Sprinkler systems
The project required special care, having a historic façade and being located in a busy area, posed several challenges that were met during its execution:
Working under tight conditions while maintaining flow of pedestrian and vehicular traffic
Shoring and maintaining the historic façade in safe conditions during construction
Coordinating material delivery with very limited storage space available at site
USDA New Poultry Facility
Beltsville, Maryland
Owner: U.S. Department of Agriculture
This project consisted of developing and constructing a completely new research facility from the ground up with covered area of about 30000 SF.
On site work included:
Demolition, utilities and storm water management
Concrete, brick work and paving
Structural steel, millwork and roofing
Interior finishes and door hardware
Mechanical, electrical, sprinkler and safety areas
Security system
The project designed to be used as a research facility had its own special requirements of ventilation systems, temperature control in the hatchery and breeder & growout wings of the building.
National Airport Canopy & Signage
Reagan National Airport, Washington DC
Owner: Washington Metropolitan Area Transit Authority
The scope of this project consisted of design and construction of a new area for the growing number of travelers at the National Airport.
On site work included:
Post tensioning system
Structural steel work
Stainless steel work
Snap fit arched stainless stell panels
Architectural composite panels
CCTV system
Public address system and signage
The project posed several challenges that were successfully met during execution:
Construction in an area under constant use by general public
Extensive coordination with owner’s staff
Very high accuracy ( < 1/16”) of work needed for snap fit panels
Working in a very limited space while maintaining emergency exits for passengers.
Addition and renovation of kitchen and dining facility
